User Tools

Site Tools


You can configure KLog to connect to your radio in this page. Hamlib is a software that allows KLog to connect your radio to send commands and receive data.

You can read the frequency and mode from your radio but also change your radio frequency and mode from KLog.

You will have to enable hamlib in the checkbox.

This setting page offers you a read-only mode that means that KLog will follow your radio and the radio will not be able to be changed from KLog.

To configure hamlib, you need to select you radio model in the selection combobox and then define all your specific serial port settings.

If you want to use a remote hamlib radio you will have to enter the IP or network name and port of the computer where the rigctld software is running.

setup-hamlib.txt · Last modified: 2021/08/28 15:00 by ea4k